Diamond Pin Wire Cutter

tungsten carbide jaws, cuts up to 0.047" (1.1 mm) diameter hard wire, 6" (15.2 cm) K-Wire Side Cutter is a versatile instrument that can be used in a variety of surgical procedures. It is specifically designed for use in cutting wire in a particular perpendicular orientation. The unique design of this instrument allows it to comfortably be set flush against the areas where the wire has been inserted and clip it at a length that makes it the best fit. A variety of spinal procedures require for the placement of wire through the newly grafted area to give additional support throughout recovery and this instrument can be used in manipulation and cutting of these wires. Additionally this instrument features tungsten carbide jaws and can cut wires up to a diameter of 1.1 mm.

tungsten carbide jaws, w/ coil spring, maximum capacity 1/16" (1.7mm), 6" (15.0 cm) End Cutter is a unique instrument designed for cutting of surgical pins or wire. Many orthopedic and neurosurgical spinal procedures require the use of such stabilization accessories to prevent trauma during recovery and confer additionally stability. This instrument is particularly well suited for end cutting which allows it to be made flush with the edge of bone or other tissue areas where it is being used. Additionally this end cutter features tungsten carbide jaws and has a maximum capacity of 1/16".

replaceable tungsten carbide blades w/ integrated rubber jaws, for max 1.6 mm drill wire, 7" (17.8 cm)Hercules-Type Front & Side Cutter is a multi-purpose instrument suitable for a variety of orthopedic procedures in which wire or pins are used. Fracture repair procedures can utilize pins to set the bone fragments or can be approximated by wrapping wire around. This instrument is ideally suited for manipulation of wire and pins as well as cutting them either from a front or a side approach. This instrument features replaceable tungsten carbide jaws with integrated rubber jaws for a maximum 1.6 mm drill wire.

tungsten carbide jaws, double-action, front & side cutting, cuts up to 1/16" (1.7 mm) diameter hard wire, 7" (17.8 cm) Flush Wire Cutter is an instrument designed for use in cutting wires during surgical procedures. A variety of procedures require the insertion of wire to stabilize an inserted graft or fracture repair. This decreases potential for trauma and increases the speed of healing. This cutter features double-action tungsten carbide jaws that allow for precise cuts on wire up to 1.7 mm diameter. This instrument can be used for both front and side cutting.